Announcement

Collapse
No announcement yet.

bandsaw motor

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • bandsaw motor

    I have an old sears (1978) 12" bandsaw,and the motor has to be replaced. The motor on it is a 1/2 hp. Can i replace it with a 3/4 hp? Will it cause any problems? Its only a $10.00 differance.

  • #2
    I could be wrong as electrical is not one of my strong suits but I think you should be alright as long as the ¾HP turns the same RPM's as the ½HP.
    ================================================== ====
    All of us could take a lesson from the weather. It pays no attention to criticism.

    Comment


    • #3
      You need to look at RPMs and shaft size. Other than that, you'll be OK. Problem is that 12" saws typically don't need anything that big. If the motor was free, then it would be worth it, but I'm not sure I would pay extra on a 12" saw.

      Comment

      Working...
      X