Announcement Announcement Module
Collapse
No announcement yet.
MS1290LZ Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • MS1290LZ

    I've had this saw for about 2 years now and it's been a dandy. However I recently realized that the cutting head isn't pivoting all the way up. I remember when it was new I could cut through a 6 X 8 now I can't get the blade over a 4X4. Something is obstructing the movement but for the life of me I can't figure what it is. Has anyone had this poblem? I'm gonna lube the heck out of it and see what happens but I don't think that's the issue. Any feed back would be appreciated.

  • #2
    The maximum cross cut on the MS1290LZ if 2"x12" or 4"x4".
    Teach your kids about taxes..........eat 30 percent of their ice cream.

    Comment


    • #3
      That wasn't in one pass, anyway the point I'm trying to make is that the pivoting action is limited by something. I can barely slide a 4X4 under the blade now

      Comment

      Working...
      X