No announcement yet.

New R4512 Installation problem

  • Filter
  • Time
  • Show
Clear All
new posts

  • New R4512 Installation problem

    I am about 95% complete with the installation of a new R4512. I am experiencing an issue. The TS that when it is dropped on its feet (not on casters) it wobbles (like those old restaurant table). I am wondering if anyone has experienced this issue.
    Things I have checked:
    1- Floor; moved it so different location
    2- When on caster (raised) it is level
    3- Took off the rubber boots (metal) , still same issue

    Thanks in advance.

  • #2
    I'm currently experiencing the same thing... I've gotten to set down and feel as solid as a rock once or twice but other than that I am experiencing the exact same thing. To say I'm frustrated is an understatement... you spend a ton (to me anyway) on this saw and expect something as simple as the legs to be even and for the darn thing not to wobble.

    Similar to you I moved it around my garage a couple times, tried raising and lowering it several times. I'm going to keep experimenting with it but eventually if it keeps up I might have to shim a leg or two.

    I'd be VERY curious to hear from anyone else about this too... you're not alone.