No announcement yet.

problem with hammer drill

  • Filter
  • Time
  • Show
Clear All
new posts

  • problem with hammer drill

    I just purchased a R841150 Hammer drill as part of the 3 piece combo. When I switch into hammer mode, the torque ring doesn't feel like it clicks in positively, and when I switch back out it often fails to switch back to non-hammer mode until I engage reverse mode.

    Is this a common characteristic? It's a minor annoyance at the moment, but feels like it might get worse over time. I just bought this stuff today, and the kits are almost completely sold out and back-ordered until after Christmas. I'm not sure what to do...suggestions?