Announcement Announcement Module
Collapse
No announcement yet.
Herculift wheels and my TS3650 Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Herculift wheels and my TS3650

    Either I've assembled my TS wrong or the herculift design is quirky (it's probably the former). My problem is that whenever I lower the herculift system, my table saw doesn't sit entirely on the feet. It sits partially on the wheels and partially on the feet. If I go under there and turn the wheels to the correct postion I can get the wheels out of the way but I do not want to have to do this everytime.

    Has anyone else noticed this problem? Please tell me that I have assembled it wrong!

    Quentin.

  • #2
    Same here, but they just barely touch. I looking at replacing the 'tall' nuts on top of the casters with regular ones.
    ken
    Poplar Branch Wood Crafts

    Comment


    • #3
      Thanks Ken, that's what I was thinking about doing too. Do you know the thread size? Have you found a source?

      Quentin.

      Comment

      Working...
      X