Announcement Announcement Module
Collapse
No announcement yet.
RS1000 Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • RS1000

    I have a RS1000 and really enjoy using the saw. I bought it a couple years ago and plan to buy the TS3650 in about a month. However, I do seem to have a problem with the RS1000 and that is that when I swing the arm to a 45 degree cut and return it to center at 90 it is not square with the fence. Has any one had this problem? Or is it an adjustment problem. I have cut maybe a 100 board feet on the saw and don't use it a whole lot and don't rip on it. Any ideas?

  • #2
    It is an adjusment in the back-read your manual!

    Comment


    • #3
      Originally posted by RadialArmSculptor:
      It is an adjusment in the back-read your manual!
      Chill out, man.

      [ 04-13-2004, 07:57 PM: Message edited by: Lorax ]
      Lorax
      "Did you put the yellow key in the switch?" TOD 01/09/06

      Comment

      Working...
      X