If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The threads, I believe are standard for any lathe. Any chuck should work. I seen several offered at the show last weekend.
try www.ptreeusa.com or www.thewoodworkerschoice.com
Tony Hinch, owner & CEO of Fisch tools had both displayed. I nearly purchased the 4 jaw. But no currently planned future projects needed it.
John E. Adams<br /><a href=\"http://www.woodys-workshop.com\" target=\"_blank\">www.woodys-workshop.com</a>