If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Dado blades would be an after market purchase and Sears or most any woodworking store would carry them. I'm not sure what the capacity of dado cut the portable TS has but I recommend you go with a stacked dado set and stay away from the wobble type.
Teach your kids about taxes..........eat 30 percent of their ice cream.
Hey, how about an out-feed table support? I'm guessin'I'll have to build one (any suggestions?)...I often cut on non-level surfaces (ie. my back yard) so it would be better if the support was "part of" the saw rather than a separate component...however, accessories...I added an Osborne miter guide...how about a zero clearance throat insert (Ridgid, Lee Valley), better blades (Forrest, Freud), etc. and then start building all the various jigs I read about!