Announcement

Announcement Module
Collapse
No announcement yet.

jeffbob

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • jeffbob

    I just purchased a used 13" ridgid planer. I put new blades in it. I ran a piece through and the rollers are not keeping it down. I jumps up and sniped my piece. I leveled the in and outbound feed tables. I see them turning slowly when I turn it on.

    Any suggestions? I have just finished my workshop and have about 1000 board feet of mesquite and cherry to get ready to build with?

    I am brand new to the forum and looking forward to passing on any good info I have.

    Thanks,
    Jeff
Working...
X