Announcement Announcement Module
Collapse
No announcement yet.
3650 rip fence slots Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • 3650 rip fence slots

    The T-bolts I have from Rockler for the T-tracks I have, don't fit, and even if I just ground them down a little, the bolt stilll wouldn't fit. So what are we supposed to use in these slots, they seem very narrow?

    Thanks,
    PJ

  • #2
    I use ¼x20 hex head bolts.
    Teach your kids about taxes..........eat 30 percent of their ice cream.

    Comment


    • #3
      Originally posted by pjmcgarvey
      The T-bolts I have from Rockler for the T-tracks I have, don't fit, and even if I just ground them down a little, the bolt stilll wouldn't fit. So what are we supposed to use in these slots, they seem very narrow?

      Thanks,
      PJ
      I found the same issue and use the same bolts Dave recommended. I have also found T-bolts at Woodcraft that are sold with smaller heads that will also fit.

      WWS
      Still enjoying all 10 fingers!

      Comment


      • #4
        I use 1/4" brass bolts that hold on toilet seats. .98 cents for a 2-pack.

        Comment


        • #5
          Originally posted by pjmcgarvey
          The T-bolts I have from Rockler for the T-tracks I have, don't fit, and even if I just ground them down a little, the bolt stilll wouldn't fit. So what are we supposed to use in these slots, they seem very narrow?

          Thanks,
          PJ
          Ya know those 3 bolts ya had left over when you assembled your saw? Guess what they're for!!
          Lorax
          "Did you put the yellow key in the switch?" TOD 01/09/06

          Comment


          • #6
            Originally posted by Lorax
            Ya know those 3 bolts ya had left over when you assembled your saw? Guess what they're for!!
            Ah Haa!!!!!!!! Now I know what they are for!! And I can quit wondering where they are supposed to go and if I forgot something. Thank You!!

            Comment

            Working...
            X