If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Those adapters work well in a drill/driver but from my experience they don't do as well in an impact driver. The first time I tried using one in my 14.4V impact driver the adapter broke in half. Thinking it might just be a bad adapter, I put in another and it also broke right away. Granted these were el cheapo adapters but a good one probably won't be cheap either.
I decided to change calling the bathroom the "John" and renamed it the "Jim". I feel so much better saying I went to the Jim this morning.
As Badger Dave,& DCDUDE mentioned, I would recomend going up to 1/2" square drive, and then you can use the heavy duty bits & tops that are good in an impact, or pneumatic tool. I recently had a (cheap & nasty) 13mm top explode in my (visor protected ) face, while using an impact tool, so a few dollars more might be well spent!
Thanks for all the ideas everyone. Truth is, I won't be using it in a impact driver. At work I frequently use a cordless screwdriver which has a impact style chuck(locks bit in place). Ideally I'd would like to find a 10mm magnetic nutdriver bit! Finding standard sizes is easy, but can't seem to find metric.