If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
MAINTENANCE NOTICE: The site will be down for maintenance on Sunday, 29 November 2015, between 12PM (noon) and 4PM Eastern. We apologize for any inconvenience!
Two possibilities come to mind. First make sure the outfeed table is EXACTLY the same height as the high point of the knives and that all the knives are the same height. Second, lay a straight edge across the tables and bring the infeed table up to the same level as the out feed. Check that the tables are flat in relation to each other (coplanar) if one sags then the gibs need to be adjusted