Announcement Module
No announcement yet.

DW7657 10" blade

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • DW7657 10" blade

    Just want to know from those who have used the Dewalt DW7657 10" table saw blade as to how the clean the cuts are when ripping/cross-cutting veneer plywood. I know it has only 40 teeth but it has been compared performing close that of the WWII blade, but I think of only in terms of hardwood.

    So if anyone has used this when cutting veneer plywood, please let me know.


  • #2
    Re: DW7657 10" blade

    I had a DW7657 and compared it directly with the WWII and TS2000. It's very difficult to tell the cuts apart. Both are good in plywood, but neither is "best" in plywood. If you're looking for the absolute best performance possible, get an 80T Hi-ATB blade like the Freud LU80, Infinity, Ridge Carbide, or Forrest Duraline. For an all around great full kerf blade, the DW7657 is nearly impossible to beat for the price...I think it's on sale for an insane price at Amazon right now (..just checked, ~$32 shipped). In a TK, the LU88 will eclipse it in some areas (~ $36 shipped).


    • #3
      Re: DW7657 10" blade

      Thanks Hewood