If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Don't sweat it, they will be shown again in a few weeks. You really didn't miss much anyway. Norm did build an outfeed table in one of the episodes. To tell you the truth I think was on here and got some ideas from mine
Just kiddin of course. His table was nice but the method he used for mounting to the TS migt be difficult to implement on the RIDGID TS. That is because of the way the fence on the RIDGID clamps on both ends of the fence.
"It's a table saw, do you know where your fingers are?" Bob D. 2006