Announcement Announcement Module
Collapse
No announcement yet.
2412 table saw motor problem Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • 2412 table saw motor problem

    My motor lost power and put out a small amount of smoke. Now it just hums, but doesn't rotate. Could a capacitor cause this or will I have to replace the motor? Has anyone had this problem?

  • #2
    Depends which device you let the smoke out of.
    I have had two motors where the caps went, a disc/belt sander that was fixed with a new cap and my RAS that required a new motor as well as a cap.
    Cheap to test by replacing the cap

    Comment

    Working...
    X