Announcement

Collapse
No announcement yet.

Ts3650

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ts3650

    I Just got a great deal on a used TS3650 table saw and would like to add a table board/router table on the saw. I am not sure the best way to install a board to the fence rails. Has anyone done this ? Any ideas ?
    Thanks,David

  • #2
    Re: Ts3650

    Use the forum search function for router table or something similar and you will find a lot of information and pictures. This topic has been discussed numerous times in here.

    Welcome to the Forum.

    Regards

    Comment


    • #3
      Re: Ts3650

      Searched: for 'router extension'

      Results: http://www.ridgidforum.com/forum/sea...earchid=286877

      Comment


      • #4
        Re: Ts3650

        I used these wire clips, , to mount the board to the spacer bar and a couple of c-clamps mounted to the right wing to act as rests and levelers for the board. Works well and if I ever decide to not use the board any longer there will be no marks or holes left on the saw to indicate it was ever there.
        Last edited by BadgerDave; 08-17-2007, 12:31 PM.
        ================================================== ====
        All of us could take a lesson from the weather. It pays no attention to criticism.

        Comment

        Working...
        X