Announcement

Announcement Module
Collapse
No announcement yet.

Looking for a tenoning jig?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Looking for a tenoning jig?

    FYI, I recently purchased a delta tenoning jig for my TS2412. The salesperson at my local woodworking supply store mentioned that there might be compatability issues using it with a Ridgid or Crafstman saw due to a slightly narrower miter track than other saws. It turns out that it was too snug to fit. However I compensated by detaching the miter track on the jig and rubbing both sides on an emery paper until it slid through the track without hang-ups. It took some elbow grease, but made for an incredibly precise fit. The jig has been working out great.
Working...
X