Announcement Announcement Module
Collapse
No announcement yet.
TS Sled - Part III Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • TS Sled - Part III

    Good day

    On this part I made some improvements and modifications mainly with the "hold down"

    Regards
    niki













































  • #2
    Re: TS Sled - Part III











































    Comment


    • #3
      Re: TS Sled - Part III











































      Comment


      • #4
        Re: TS Sled - Part III

        Comment


        • #5
          Re: TS Sled - Part III

          i dont see the point in all that engineering. just use the table saw fence with a push stick

          Comment


          • #6
            Re: TS Sled - Part III

            You are correct but...........

            Considering the simple fact that for some mysterious reason, most of the table saws are missing the blade guard, splitter and, the anti-kickback pawls are dangerous in this case, I would not dare....

            Yeap, many ways to skin a cat...this one is just of them...

            And on the next parts, you'll see how I'm ripping or cross-cutting an 1/2" cube into 2 or, an 1/2" strip into 2 that, I don't thing can be done just with a push stick...

            As I said on part I "I made this sled to rip and cross-cut small (very) pieces".......

            Comment

            Working...
            X