Announcement

Collapse
No announcement yet.

TS Sled - Part V

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • TS Sled - Part V

    Good day

    On this part, I made a new wider (or longer) "Hold-Down plate" for holding long pieces better while ripping.

    As you'll see, I used screws to connect the support to the sled but later, I used two dowels instead of the screws for faster "ON-OFF" of the hold-down.

    Another aid is the "hold-down block" for cross-cutting

    It's still not the final and a few changes are going to take place...

    Regards
    niki











































    Last edited by niki; 01-26-2009, 03:02 AM.

  • #2
    Re: TS Sles - Part V

























    Comment


    • #3
      Re: TS Sled - Part V

      Quite intricate Niki.
      Does this mean that you are finished with your curing, or were these photos taken earlier?

      Comment


      • #4
        Re: TS Sled - Part V

        Thank you Paul

        Well, I'm still far from the end of my curing (at least, another 3 months)...

        Those pics are from the last summer but when I went through my posts, I noticed that I didn't post it here yet so, I'm doing it now to complete the "list" (it's the only forum on the internet that you can find all my posts/jigs).

        As for "Intricate", well, maybe a little bit but, as you will see on the next (part 6) and the "final version", I removed/replaced a few things to simplify the operation.

        Regards
        niki

        Comment

        Working...
        X