No announcement yet.

Pipe Clamps - 1/2" or 3/4" and Why

  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Re: Pipe Clamps - 1/2" or 3/4" and Why

    Originally posted by Bob D. View Post
    I was just about to ask about the Rockler clamps. They appear to have some advantages in design over the Pony. All Pony and Jorgenson clamps used to all be made on the USA, but now it seems that some of their clamps are made overseas. I don't know if that includes their pipe clamp line or not.
    To follow up on my question above. I emailed them and below is their reply;

    Good Morning
    Our Pony Pipe Clamps, Handscrew & Spring clamps are still made in the U.S.A.

    Customer Service
    312-666-0640 x-112

    -----Original Message-----

    Sent: Saturday, February 21, 2009 9:10 PM
    Subject: Clamp manufacturing

    Where are your clamps made now? They used to all be made in the USA.

    I am asking about the 1/2" and 3/4" Pony pipe clamps; Adjustable C clamps; and Jorgenson hand screws, bar clamps, and spring clamps.

    I replied thanks and glad to here it, I will buy more.
    "When we build let us think we build forever. Let it not be for present delight nor for present use alone. Let it be such work that our descendants will thank us for, and let us think, as we lay stone upon stone, that a time is to come when these stones will be held sacred because our hands have touched them, and that men will say, as they look upon the labor and wrought substance of them, "See! This our fathers did for us."
    John Ruskin (1819 - 1900)