No announcement yet.

Pipe Clamps - 1/2" or 3/4" and Why

  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Re: Pipe Clamps - 1/2" or 3/4" and Why

    Originally posted by Bob D. View Post
    I was just about to ask about the Rockler clamps. They appear to have some advantages in design over the Pony. All Pony and Jorgenson clamps used to all be made on the USA, but now it seems that some of their clamps are made overseas. I don't know if that includes their pipe clamp line or not.
    To follow up on my question above. I emailed them and below is their reply;

    Good Morning
    Our Pony Pipe Clamps, Handscrew & Spring clamps are still made in the U.S.A.

    Customer Service
    312-666-0640 x-112

    -----Original Message-----

    Sent: Saturday, February 21, 2009 9:10 PM
    Subject: Clamp manufacturing

    Where are your clamps made now? They used to all be made in the USA.

    I am asking about the 1/2" and 3/4" Pony pipe clamps; Adjustable C clamps; and Jorgenson hand screws, bar clamps, and spring clamps.

    I replied thanks and glad to here it, I will buy more.
    "It's a table saw, do you know where your fingers are?" Bob D. 2006


    1/20/2017 - The Beginning of a new Error