Announcement Announcement Module
Collapse
No announcement yet.
Dimensions R4511, couldn't find them anywhere Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dimensions R4511, couldn't find them anywhere

    Looking for the depth, esp vs the TS3660. Someone said it was the same, someone else said 2" shallower.

    I have a TS3660 on hold for $379 ...home depot didn't have the specs on the new saw yet.

    Thanks

  • #2
    Re: Dimensions R4511, couldn't find them anywhere

    About 31" is what I've got, not including fence. Add about 3" out the back for the fence.
    This is for the 4511.
    Last edited by barrsurf; 03-02-2009, 05:22 PM.

    Comment


    • #3
      Re: Dimensions R4511, couldn't find them anywhere

      The 3660 is ~ 42" from the front of the fence to back of the motor. The R4511 should be 27" of table, plus the width of the front and rear fence rails.

      Comment


      • #4
        Re: Dimensions R4511, couldn't find them anywhere

        So maybe 34-36" deep overall? more like a 6-10" savings of depth.

        Comment


        • #5
          Re: Dimensions R4511, couldn't find them anywhere

          Originally posted by alkemyst View Post
          Looking for the depth, esp vs the TS3660. Someone said it was the same, someone else said 2" shallower.

          I have a TS3660 on hold for $379 ...home depot didn't have the specs on the new saw yet.

          Thanks
          I just measured mine. The granite is 40" wide and 27i/8" deep. It's 31" front to rear across the rails. I don't own a 3660. A friend of mine has one but after looking at mine he claims he would absolutly buy the 4511 if he was buying a saw now. He alway's spoke well of the 3660 tho. He feels the 4511 is a lot of saw for the money. So far I agree with him.

          Buck

          Comment


          • #6
            Re: Dimensions R4511, couldn't find them anywhere

            more budget drove my decision + some of the mods that are available that I can use. I have a smaller workshop (14x16') so I would have appreciated the shallower depth.

            Comment


            • #7
              Re: Dimensions R4511, couldn't find them anywhere

              Originally posted by alkemyst View Post
              So maybe 34-36" deep overall? more like a 6-10" savings of depth.
              ~ 11" overall difference in depth.

              Comment

              Working...
              X