I finally got my r4511 assembled after it initially came with two left wings (that's a whole nother issue). Now I have it completely assembled and cannot get the splitter adjusted correctly. It is about an 1/8 of an inch too far to the right of the blade. I am using a square and have loosened the adjustment scres as the manual says but I cannot get it to move. Am I supposed to push it to bend it into position or is there something I am missing? When I loosen all four adjustment screws it doesn't seem to offer any adjustment by doing that so I thought maybe I am just suppoed to bend the splitter into place. Anyways I am lost...any input would be appreciated.