If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
MAINTENANCE NOTICE: The site will be down for extended maintenance on Sunday, October 2, 2016, between 12 Noon and 6 PM Eastern. We apologize for any inconvenience!
It's a very good saw, especially for the jobsite...if you're planning on making it the only saw in your shop you should know the maximum cut is 18 3/8"...the 2424 or 3612 would be a much better shoice in my opinion.
Kelly C. Hanna<br /><a href=\"http://www.hannawoodworks.com\" target=\"_blank\">Hanna Woodworks</a>