Announcement

Announcement Module
Collapse
No announcement yet.

New RAS Top

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • New RAS Top

    The MDF top on my Radial Arm Saw is starting to look like a battle field so it is about time to replace it (I have already used both sides). It looks like 1" MDF, but I haven't seen MDF in that thickness readily available. It looks like I can use 3/4" MDF, but I was wondering if anyone else has a better solution.

    Any suggestions?
    Mark

  • #2
    While it's been a while since I had my RAS, seem to remember it was 3/4" stock. Of course you could always laminate two 1/2" pieces.
    Dave

    Comment

    Working...
    X