Announcement Announcement Module
Collapse
No announcement yet.
R4511 and Unifence? Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • R4511 and Unifence?

    Good Afternoon-
    I just wanted to see how feasible it would be to use a Delta Unifence and rail on my new R4511. I already have this fence system on an old Craftsman saw, and would prefer it over the stock Ridgid system. The Unifence rail mounts via hex bolts that slide into a machined t-slot on the back on of the rail, and the other side of the bolt is tightened to snug up the rail, so the granite top might render this difficult, if not impossible, but I was just wondering if anyone else that is familiar with the Unifence system and had considered this as an upgrade possibility. Can anyone think of a way to make this work? Thanks in advance for your help.
Working...
X