If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
MAINTENANCE NOTICE: The site will be down for maintenance on Sunday, 29 November 2015, between 12PM (noon) and 4PM Eastern. We apologize for any inconvenience!
I like the Wood Slicer resaw blade from Highland Woodworking.
Haven't resawed any hard maple, but I have done plenty of
cumaru (Brazilian teak) and ebony, both very dense.
I find that their blade leaves very little saw marks and it
only takes a pass or two through the thickness planer
to finish it.