Announcement Announcement Module
Collapse
No announcement yet.
tp1300 Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • tp1300

    Proud new owner of this machine. I ran a couple of test pieces, and found that some of them are sniped. Not that bad, can sand out. I tried adjusting the in feed and out feed table, but did not help. Should I be running the board on the center of the knives?

    Thanks in advance for any help.

    Jim

  • #2
    Where you run doesn't make any difference on mine. Waxing the infeed and outfeed along with the platen makes a huge difference. HTH
    \"Is it Friday yet?\"

    Comment

    Working...
    X