No announcement yet.

scroll saw

  • Filter
  • Time
  • Show
Clear All
new posts

  • scroll saw

    Hello all,first time hope I'm doing this right.
    I have a Ridgid scr/saw and like it very much but the only thing I don't care to much for is the thumb screw and tensioner set up (plays a number on the finger and thumb after a while)It's not bad when doing bigger cuts but when you a lot of small ones it gets rough,I was wandering if any one has modified one or if there is a quicker set up to use in place or should I not FRET about it anymore (he he).Any info would be helpful

    Keep the dusta flying!!!!