Announcement Announcement Module
Collapse
No announcement yet.
bolts for the back rail on the r4511 Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • bolts for the back rail on the r4511

    I have been spending a little bit of time each night this week assembling the r4511 table saw and have come to a bit of an stumbling block. It seems in my unpacking and moving pieces around the garage, I can't find the bolts that attach the back rail to the granite table top. Does anyone know the size of them so I can pick up some replacements at a local hardware store?
    Thanks in advance.
    Mike

  • #2
    Re: bolts for the back rail on the r4511

    5/16" -18 x 5/8" hex head

    listed in parts list for figure C in the repair sheet

    Comment


    • #3
      Re: bolts for the back rail on the r4511

      if you have the time, just call ridgid CS and have them send you the missing pieces.
      there's a solution to every problem.....you just have to be willing to find it.

      Comment

      Working...
      X