Announcement Announcement Module
Collapse
No announcement yet.
TS3650 Rip Fence Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • TS3650 Rip Fence

    Hi,

    Anyone else experience this?

    The rip fence on my TS3650 rides 'high' near the adjustment nuts on top near the lock-handle. In other words, when I'm ripping a board longer than a few inches, the board is not flat on the table , riding higher at the 'infeed' end.

    I'm pretty sure I have the rails set up properly... Anyone?

    Thanks,

    Tom

  • #2
    Re: TS3650 Rip Fence

    I'll bet that the rails aren't set-up correctly but also look under the fence where it rides on the front rail to make sure that there is not a sawdust build-up.
    Teach your kids about taxes..........eat 30 percent of their ice cream.

    Comment

    Working...
    X