Announcement

Collapse
No announcement yet.

Lathe help needed

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Lathe help needed

    I have a WL1200, I am looking for a duplicator to fit this machine, and also a jaw clamp, thank you for any assistance

  • #2
    Hi: according to this info a duplicator is not available for the WL1200. I would have a look at a few of the competitors and see if there's one that will fit or can be modified to fit. I have used the Oneway chuck for about ten years which has worked very well for my application, bowls, vessels.
    Good luck
    Ross

    http://www.ridgidwoodworking.com/faqs/WL_ACCESSORY.htm

    http://www.oneway.on.ca/

    [ 05-09-2003, 07:36 AM: Message edited by: Ross J ]

    Comment


    • #3
      Duplicators for the tubular bed lathe is rare. I remember a long time ago seeing one advertised. Either in the back of some woodworking mag or on the net somewheres.
      John E. Adams<br /><a href=\"http://www.woodys-workshop.com\" target=\"_blank\">www.woodys-workshop.com</a>

      Comment

      Working...
      X