Announcement

Collapse
No announcement yet.

3650 table saw back cover

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • 3650 table saw back cover

    Hello all, I have been reading on this forum for a few weeks now and have really enjoyed the information found here. The question I have is I am trying to seal up my 3650 as much as possible and cannot figure a good way to do the back. I made a niffty dust chute for the bottom which helps alot but I really need the back covered also with out compromising the tilt ablility of the saw. If you could post some pictures of your back covers I would greatly appriciated Thanks

  • #2
    There are a few tricks around...

    DC thread



    Comment


    • #3
      I built mine out of 1/8" hardboard and attached to the back using magnets from a refrigerator door. Split in two for easy mounting / removal.

      I have the pattern in Powerpoint (for a 3612) if you want a copy.

      Brian

      Comment


      • #4
        I'd like a copy of that template. I have a 3612.

        thanks,
        Michael

        Comment


        • #5
          Brian, I would also like a copy of that template. Thanks
          Larry

          Comment


          • #6
            I would also like a copy of the template. Can you e-mail it to robritch at comcast dot net
            -Rob<br /> <a href=\"http://home.comcast.net/~robritch/\" target=\"_blank\">http://home.comcast.net/~robritch/</a> <br />Damn, I hit the wrong nail again. Ouch that hurts

            Comment


            • #7
              thanks brian for the template you can't get much easier than that. when I figure out how to post pics I put up pic of th under chute I built for my 3650 that puts the dust next to the saw instead of under it on the lift system if you interested. tanks again.

              Comment


              • #8
                Brian,

                Thanks for the template. Now I just need to find time to get it made.
                -Rob<br /> <a href=\"http://home.comcast.net/~robritch/\" target=\"_blank\">http://home.comcast.net/~robritch/</a> <br />Damn, I hit the wrong nail again. Ouch that hurts

                Comment

                Working...
                X