I had cut up a couple of 4x8 sheets of mdf for base and crown moulding and saw the orange wearing off the center of the plate.(having some of that HD orange may be a good thing) If I fully tighten the holding screw it causes the plate to be pinched to the rear and flex above the table. Is this normal? My old sears saw plate just snapped in, much better in my opinion. I had to enlarge the screw opening to get the plate out inorder to remove the plate without fully removing the screw. I have no experience with Rigdig plates.
Announcement Announcement Module
No announcement yet.
Throat plate flex on 3650 Page Title Module
Move Remove Collapse