If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
MAINTENANCE NOTICE: The site will be down for extended maintenance on Sunday, October 2, 2016, between 12 Noon and 6 PM Eastern. We apologize for any inconvenience!
Hello Driver, I've read other posts somewhere about the same issue and that some people drove the roll pins out of the aluminum pedal and lever so they could rotate them 180 degrees to position them correctly.
I found assembling them a little confusing at first and initially thought there might be a problem but it was just me confusing things.I have attached a couple pictures - hope this helps.