Announcement

Collapse
No announcement yet.

TP1300 table/snipe

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • TP1300 table/snipe

    I had some snipe for the first time with my 1300 in two spots, not on the end of the boards.

    When adjusting the tables, just right of center were two impressions of the feed rollers about 2" wide. The snipe I was getting on some of my boards looked almost exactly the same distance apart as the feed rollers.

    Is it time for a new table?

  • #2
    Re: TP1300 table/snipe

    Before doing anything else, I would very carefully check the knives for sharpness and clean the rollers.
    Any man who thinks he can be happy and prosperous by letting the government take care of him better take a closer look at the American Indian."
    ------- Henry Ford

    Comment


    • #3
      Re: TP1300 table/snipe

      Thanks Dave.

      Yeah, probably time to switch the knives.

      Comment

      Working...
      X