Announcement Announcement Module
Collapse
No announcement yet.
Converting TS2424......for Jake. Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    I cannot find tapes that go on the rail that are as nice as the original. Has anyone got the ones for the currrent model and tried to use them. I heard thy are a bit too wide. I have looked around but the only ones I found that I liked were from woodcraft. They were over $25 for both. This is about double all of the others. I would really prefer to have the metric side nearest the saw table. It does not sound like a big deal but the one I bought was the opposite and I found it very hard to read. The pointer on the fence is not tall enough.

    [ 06-27-2004, 08:26 PM: Message edited by: messmaker ]

    Comment


    • #17
      Messmaker,
      I made a router table and I did not use any of the hardware listed by Big J. Just make sure that the width dimension is 27". You can shim with washer if necessary. I will post a picture when I figure how to.
      Steve

      Comment


      • #18
        I just added a cast iron extesion that I bought from a forum member and slid the rails over. I carefully peeled off the indexing and re-attached after re-alignment. Works well...and cost about $25!
        keep makn\' sawdust!...just don\'t breath any.

        Comment

        Working...
        X