Announcement Announcement Module
Collapse
No announcement yet.
R4512 dado / splitter question Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • R4512 dado / splitter question

    I have installed an eight inch dado blade on my table saw. I am making cabinet doors with 1x3's and 1/4 plywood. The problem is the splitter will not let the 1x3 pass because it is still set up for a 10" blade. Is it ok to remove the splitter and if so, can someone tell me how?
    Thanks.

  • #2
    Re: R4512 dado / splitter question

    I figured it out. I was able to remove the two allen screws that hold the splitter on and remove it.
    thanks.

    Comment


    • #3
      Re: R4512 dado / splitter question

      Originally posted by ingram77 View Post
      I figured it out. I was able to remove the two allen screws that hold the splitter on and remove it.
      thanks.
      There is no need to do all that. Just unlock it and pull straight up to remove the splitter.
      SSG, U.S. Army
      Retired
      K.I.S.S., R.T.F.M.

      Comment

      Working...
      X