Announcement

Collapse
No announcement yet.

Tablesaw Rip Fence

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Tablesaw Rip Fence

    I've had the TS2412 Table Saw for 2yr.
    No real precision work, til now.
    The Rip Fence is not parallel to the miter
    slot of the table. It's about 1/32 closer
    to the slot on rear than the front.
    Is there any way to adjust it, or is the
    Rip Fence defective and I never knew it.

  • #2
    I just looked in the on-line manual for the TS2412 model 0. Yours might be a bit different, but in this one, fence alignment starts on the top of page 22. It's a rather simple process, and the manual even includes a couple drawings to show exactly what needs to be done.

    This might be a good time to run the whole tuning process on the saw. Most complaints I have heard on contractor's saws are solved with a good tuneup. Kinda like pulling half the sparkplugs out of your car, just doesn't run so good.

    Dave

    Comment

    Working...
    X