Announcement

Collapse
No announcement yet.

Table saw rip fence problem

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    I just bought the 24/12 this past Friday. I liked the fence. I had to adjust it a little bit since it was off by about 3/16, but once that was done, it was smooth.

    Comment


    • #17
      ok, My husband who just purchased the TS3612. Is having a problem with the rip fence after the soild part of the table when you get on the right wing its off 1/16. How do you fix it?? He has done all the things he has read to do and more. We have read the other posts as to the right wing not being square. He has measured corner to corner it was a 16th off. He also used a combination Square from the miter slot and the front is a 16th farther away then the back.

      Comment


      • #18
        Just like the other replys in this thread. If the wing isn't milled right, simply have it replaced. I said it a year and 6 days ago, and I still say it.

        Dave

        Comment


        • #19
          Clutter,

          Call 1-800-4RIDGID and speak to customer service, they should be able to take care of the problem.

          Jake

          Comment

          Working...
          X