If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Does any one know wher I can get an adaptor for the 4512 table saw dust hopper to convert it down to the size of a shop vac hose?
I picked up the following from woodcraft. Rigid Flex Hose 4" x 36" p/n 149581 and 4" x 2 1/4" funnel reducer p/n 147759 and a couple 4" hose clamps. I got the wrong reducer and the 2 1/4" end of the adapter was the same size as my shop vac hose. I picked up a 2" to 2" plastic pipe coupling and a couple more clamps. works great. I got the funnel type reducer after readiing reviews about the short flat reducer (p/n 144534) getting clogged up. I haven't had any problems with anything getting stuck in the bends of the flex hose or the funnel.
Sounds like mine is probably set up pretty much the same way as me5269's. It was attached to a large Sneers Shop Vac. It worked well, but I'll be changing my dust collection system to include a small cyclone and dust extractor, shortly.