Announcement

Announcement Module
Collapse
No announcement yet.

Aligning the blade to the miter slot

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Aligning the blade to the miter slot

    I'm feeling some pain. I tried to align the blade on me TS2424 last night and the micro-adjust doesn't seem to move it at all. I even tried taking out screws and using just one to see if a single screw would adjust the blade and still nothing. I followed the instructions in the manual exactly as far as I could tell. Is there a trick with only loosening up the trunion bolts a certain amount? Any help is greatly appreciated.

    Best,

    Rob
    Tax Refund = Router + Dust Collection + New Fence

  • #2
    Robert,
    Re your question on alignment with miter guide etc.

    If you go to the "TIPS & TECHNIQUES" section and look for a post entitled "Heel Adjustment Question" by Dave Walker at 02-13-2002 09:15a.m.. You will see 5 posts which will answer your problem I suspect.

    Cheers Ivor

    Comment

    Working...
    X