Announcement

Announcement Module
Collapse
No announcement yet.

Blade alignment-TS2424

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Blade alignment-TS2424

    I own a TS2424 1. My saw blade was not in alignment with the miter slot. I have a TS aligner Jr. and attempted to solve the problem. When I loosened the front trunnion it shifted towards the right when standing at the rear of the saw. Now the blade is about 1/32"-1/16" from the table insert. I can't get the front trunnion to move away to maintain at least an 1/8" clearance as reccomended in the manual. Any tips?

  • #2
    I figured it out. The tilt mechanism was keeping the trunnion pushed over to one side

    Comment


    • #3
      Re: Blade alignment-TS2424

      I have exactly the same problem, but when I mess with the tilt I lose the 90 degree tilt.

      Comment

      Working...
      X