If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Basically I am building a router table from some plans I got out of a book. The plans call for a 48" miter slide track and a 48" t-track. My question was what is the difference between the two pieces of equipment? wouln't most miter gauges slide in a t-track?
I use Incra track for most things because it is pretty cheap and iuses standard 1/4-20 bolt heads. the Rockler track uses toilet type bolts which are more expensive, harder to find, and not available in the lengths like standard bolts.