If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hergy's right, the TS2400 is not able to run on 240v power. The jobsite saw has a universal motor so it is much less susceptible to low voltage than an induction motored machine and thats where the advantages of 240 over 120 show up. You are a lot less likely to have a voltage drop across the line on 240v than 120v.