Announcement

Announcement Module
Collapse
No announcement yet.

TP1300 Planer Problems

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • TP1300 Planer Problems

    My planer has been great so far but now once in awhile when a board is going through it, it stops rolling and I have to push it through. I took it apart and checked adjustments and everything was clean anybody have any ideas what I should look for or check. Thanks Rick

  • #2
    First clean the infeed and outfeed rollers real good with a solvent such as mineral spirits. Then clean the main table and wax it. The wax on the main table is the most important step.

    Jake

    Comment


    • #3
      OK... Jake I'll try it Thanks Rick

      Comment


      • #4
        I've had the same problem. I clean and wax and clean and wax but it still runs 2 or 3 boards through and it starts all over again.I sometimes get mad and wonder if all planers are like this.Can anyone tell me if other planers are the same way or is it mostly Ridgid???

        Comment

        Working...
        X