If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
After installing rip fence I adjusted the fence parallel to the miter slot. Then checked the fence for 90 degree to table top. It is approx 2 degrees past 90. No adjustment for this that I can see. Is this acceptable.
You can adjust this by playing with the fence rails. loosen them just enough that you can move either end up and down slightly. If the fence is 2 degrees to the right (top of fence further away from the blade) lift the right side of the rails, if it is to the left lift the left end of the rails. That should allow you to get it perpendicular (sp) to the table
-Rob<br /> <a href=\"http://home.comcast.net/~robritch/\" target=\"_blank\">http://home.comcast.net/~robritch/</a> <br />Damn, I hit the wrong nail again. Ouch that hurts