Announcement

Announcement Module
Collapse
No announcement yet.

67.5 MITRE cut??

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • 67.5 MITRE cut??

    I have installed a new kitchen and need to cut a 67.5 in angle (135 degree corner) to complete the light molding. My saw only goes to 50 degrees so there must be another way. Any advice would be welcome as I have gone through a stack of scrap trying to figure it out.
    Thanks,
    Harvey
    If your gonna fix it...do it right

  • #2
    set the saw at 22.5
    90 - 22.5 = 67.5

    Comment


    • #3
      Thanks Wayne...feel stupid now because it is so simple. I did cut some pieces at 22.5 but never checked the discarded "other" half. I was so used to working with the 22.5 on many of the corner cabinets I just had a mind blank. I will be back on the job tomorrow and will finish up this last piece of moulding.
      Harvey
      If your gonna fix it...do it right

      Comment

      Working...
      X