Announcement Announcement Module
Collapse
No announcement yet.
Need help, please - Tablesaw Assembly question Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Need help, please - Tablesaw Assembly question

    Hello. New guy.

    Wasn't sure where to post this but I figured the woodworkers would know as much about a tablesaw as anyone:

    I'm assembling the TS3650 10". I'm at the point of installing the Rip Fence Guide Bars. Now, the instructions say use a straightedge to align the "Mark on Rear Guide Bar" with the blade. Simple, right - but there is NO mark on the rear guide bar. Does anyone know any other way I can make this alignment? Is there some point I can measure from to make this alignment?

    Thank you.

  • #2
    The sticker must have fallen off. The mark is 14 3/16" from the left end of the rail as viewed from the front of the saw. Hope this helps.
    SSG, U.S. Army
    Retired
    K.I.S.S., R.T.F.M.

    Comment


    • #3
      Originally posted by TOD
      The sticker must have fallen off. The mark is 14 3/16" from the left end of the rail as viewed from the front of the saw. Hope this helps.
      That's exactly what I needed to know. Thank you.

      Comment

      Working...
      X