If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just changed the blade for the first time on my miter saw. Doing some baseboard replacement pieces. Ran a few but now the saw won't run. Breaker is fine. Brushes seem fine. Any suggestions why the saw won't run?
Hi it may sound stupid but when I was working in my bedroom I plugged (?) the saw in and it did not work ! Breaker was ok everything was great then I realized the outlet worked on a light switch which was off. Just an idea .AnthonyD